Radio Shack Vu Qube V10 Benutzerhandbuch
Vu Qube
8
V10-6/1007
Installation
(continued)
2. Drill holes for mounting bracket with proper size depending on
fasteners used.
./4% The installer is responsible for determining the most appropriate
fastener to secure the bracket to the cab. Depending on the cab material,
fasteners such as lag screws, well nuts, sheet metal screws, toggle
bolts and T anchors may be used. Fasteners should always be used in
combination with compatible sealant to environmentally seal the holes after
installation.
fastener to secure the bracket to the cab. Depending on the cab material,
fasteners such as lag screws, well nuts, sheet metal screws, toggle
bolts and T anchors may be used. Fasteners should always be used in
combination with compatible sealant to environmentally seal the holes after
installation.
3. Mount bracket to cab using fasteners.
4. Seal holes with a sealant compatible with cab, faring, or air shield
material, depending on where Vu Qube is mounted.
5. Drill hole to pass the harnesses inside the vehicle.
./4% It is an option to run the wiring down the back of the cab and up into
the cab through an access bay.
the cab through an access bay.
Mounting Antenna to Bracket
1. Place Vu Qube on bracket.
s
positioned toward the cab (front of the vehicle) and to side where hole
is drilled to run wires inside the cab.
is drilled to run wires inside the cab.
Figure 2. Face connections for wiring towards the back of the cab.
Back of cab
Coaxial Cable Connection
Face towards back of the cab.
Position connector on side
you will run coaxial cable.
2. Secure Vu Qube to bracket by fastening with nuts provided.
Be sure to tighten nuts adequately to ensure Vu Qube is securely
in place.
in place.