Primera Technology Network Disc Duplication & Printing System Benutzerhandbuch

B.

CLEANING THE XRN

Use a clean, lint-free rag with a small amount of ammonia 

window cleaner to clean the XRn's outside case and trays.  

This type of cleaner is very effective on inks that may 

accumulate on the printer tray.  Stronger cleaning solutions are

NOT recommended because they may damage the paint and

plastic materials from which the parts are manufactured.
Always disconnect the XRn’s power cords before cleaning.

Resume operation only after the surfaces are completely dry.

C. PERFORMING A ROBOTIC SELF-TEST

To ensure that everything is working properly, a 

Self-Test

 

feature is built in to your unit.  In this mode, the Robotic 

Disc Transporter will go through the motions of picking and

placing a disc to ensure proper working order. Perform the test

by doing the following steps:
• Load some discs into the Right Bin
• The cover must be closed for this operation to complete.

However, in order to access the buttons you must open the

cover. To get around this problem simulate closing the

cover by activating the cover lock sensor.  You may do this

by putting an object such as a folded piece of paper in the

slot where the lock would normally be located.

• With the unit turned on, press the Cartridge Button
• While holding the Cartridge Button, press the 

Power Button        until the robotics start to move. 

• Release both buttons
• To stop the test, wait until the disc has moved to the Right

Bin and press the Power Button.

510991.qxd  6/15/2007  10:09 AM  Page 42