Panasonic Arbitrator 360 Bedienungsanleitung
10
10
Administrator.Setup
.(continued)
Auto.Power.OFF
Set the status after the Memory Card Video Recorder
is turned off.
Power.Off.Time
Select the time required from the ACC is turned off
up to the Memory Card Video Recorder is turned
off.
0, 10, 20, 30, 60, 90, 120, 180 (minutes): The
0, 10, 20, 30, 60, 90, 120, 180 (minutes): The
recorder is turned off after the specified time.
After.Upload: The recorder is turned off after
uploading is finished.
Action after uploading is finished
When Power Off Time is set to After Upload, select
which action is to be taken by the subject(s) after
uploading is completed.
Apply To and Action Specified
Select which one's uploading is to be observed, and
the action to be taken
APPLICATION.ONLY: Close
LAPTOP.ONLY: Lock, Standby
APPLICATION.AND.LAPTOP: Lock Log off,
LAPTOP.ONLY: Lock, Standby
APPLICATION.AND.LAPTOP: Lock Log off,
Shutdown, Stand by
Timeout[s]
The time required from the specified action is finished
until the recorder is turned off can be specified.
Setting.values:.
30, 60, 90, 120
(seconds)
Note
When the vehicle’s ignition switch is set to ACC-OFF with
Upload Mode on the File Transfer screen in Config setup
set to MANUAL and Power Off Time on the Rec/Play
screen set to AUTO, uploading will start automatically.
Upload Mode on the File Transfer screen in Config setup
set to MANUAL and Power Off Time on the Rec/Play
screen set to AUTO, uploading will start automatically.
Init.Settings.after.power.ON.(Rec/Play)
Set the status after the Memory Card Video Recorder
is turned on.
Init.Preset.Select
Select a Preset setting.
Preset1, Preset2, Preset3: Either of Preset1,
Preset2, Preset3
LAST: The setting upon the last power-off will be
restored.
Init.Video.Out.1
Select which signal is to be output from the [VIDEO
OUT 1] connector of the Memory Card Video Recorder
as through output.
CAM1: Input signal to the [CAMERA 1] connector
CAM3: Input signal to the [CAMERA 3] connector
Video.Out2: Encoded signal
LAST: The setting upon the last power-off will be
CAM3: Input signal to the [CAMERA 3] connector
Video.Out2: Encoded signal
LAST: The setting upon the last power-off will be
restored.