Bunn LPG-2E Benutzeranleitung

4

 

The grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15  amp, single 

phase, 60 Hz for 120V models; and 100 volts ac, 15 amp single phase, 50Hz for 100V models.

P1028

P1029

 

OFF - (upper position) Switching to this position stops all operation of 

the grinder.

 

ON - (middle position) The switch will return to this position after a grind 

cycle has begun and will remain in this position after grinding has ceased.

 

START - (lower, momentary position) Pressing the switch to this position 

and releasing initiates a grind cycle.

- Switching to this position allows beans to be ground from the left 

hopper.

- Switching to this position allows beans to be ground from the 

right hopper.

27091 042211

Bunn-O-Matic

®

 Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance 

should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic

®

 Corporation at 

1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.

6-Month 

Weekly Cleaning plus replace the dechaffer assembly.

1.  On grinders with slide plates check the slide plates and clean. 

2.  Inspect and clean/replace burrs and grind chamber if necessary.

3.  Adjust the burrs and grind time to your specifications for particulate size and throw weight.