West Elm Rustic wood wall mirror Montageanweisungen
page 1 of 1
mounting instructions
9568981- 06/07
: rustic wood frame mirror
NOTE:
• Stud mounting is recommended. Use proper hardware
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store. For your
safety, installation by two people is recommended.
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
the use of all chemicals and household cleaners.
drywall anchor 2x
screw 2x
A
B
6
1. Hold mirror at desired location. With a pencil, mark on wall the top
outside corners of the mirror. These marks will be used to determine
the location of the mounting hardware.
outside corners of the mirror. These marks will be used to determine
the location of the mounting hardware.
2. Measure down from the top of the mirror to the top of the D ring.
Measure in from the side of the mirror to the top of the
D ring. Record these measurements on the wall, using the
marks in step 1 as a guide. Align the two measurements until they
intersect. This is the insertion point of the mounting hardware. Use
a carpenter's level to ensure the mirror will be level.
Measure in from the side of the mirror to the top of the
D ring. Record these measurements on the wall, using the
marks in step 1 as a guide. Align the two measurements until they
intersect. This is the insertion point of the mounting hardware. Use
a carpenter's level to ensure the mirror will be level.
3. For stud mounting: skip to step 4. For drywall mounting: using a
Phillips head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
Phillips head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
are flush with the wall.
4. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/2" between the back of the screw head and the wall.
approximately 1/2" between the back of the screw head and the wall.
5. Align D ring over the screw heads.
6. Slide the mirror down until it rests on the screws. Tighten or loosen
screws as needed to fit the mirror snugly against the wall.
screws as needed to fit the mirror snugly against the wall.
!
For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
3-5
A
B
1
2
2
2
2