Honeywell Garage Door Opener 6160EX Benutzerhandbuch

Adding and Removing Keyfobs.

The Keyfobs used on this system employ high security KEELOQ

Rolling Code Encryption to make them virtually impossible to
duplicate.

Adding Keyfobs
With the system in DAY mode at the keypad:
1.  Enter master user code, 8 (CODE), and user number (1-8).
2.  Wait for double beep. Display says awaiting fob.
3.  Press all four buttons on the fob (receiver may beep at this point),

then release buttons (on the 6160RF and 6128RF keypads, the fob
serial number will be displayed).

4. Press any three buttons on the fob until a double beep is heard,

then release buttons).

5. Press and release any single button on the fob. A moment later a

double beep is heard.

The fob is now added to the system.
Note:

If at any time a triple beep is heard, the procedure has failed.

Removing Keyfobs
Any keyfob can be removed from the system as follows:
1.  Enter master user code, 8 (CODE), and user number (1-8).
2.  Wait a couple of seconds for a double beep.
3.  Press *. A double beep confirms deletion.

Adding and Removing Keytags

Adding Keytags
With the system in DAY mode at the keypad:
1.  Enter master user code, 8 (CODE), and user number (1-8).
2.  Wait for double beep. Display says awaiting fob.
3.  Hold card in front of LED’s to add it in.
4.  Wait for double beep then remove card.
5.  Ignore request to press a button (this is for RF fobs).