Bunn LCA-1 Benutzeranleitung

19

 

When an error has occurred, the Warning LED will be flashing. Open the door to view the LED Display and 

record the Error # shown on the display. Refer to the list of Error Codes below to identify the problem. The  

troubleshooting guide is provided to suggest probable causes and remedies for most problems. If the problem 

remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department.

Pump Error

Motor or RPM Sensor failure. Check 

motor and RPM  

 

 

Sensor wires for shorts, loose or open 

connections.

Heating Time Too Long

Tank Heater ON continuous for more 

than 1 hour. 

Check heater wires for loose or open 

connections.

Fill Time Too Long

Fill Valve ON continuous for more than 

15 minutes.

Check: Water turned OFF. Refill Valve 

disconnected or faulty.

Tank Temp Sensor Error

Sensor reading Out Of Range (High 

or 

Low).    

Check Sensor wires for shorts, loose 

or open connections.

Dispense Time Too Long

MENU

(-)

(+)

MENU

(-)

(+)

MENU

(-)

(+)

MENU

(-)

(+)

MENU

(-)

(+)

Dispense or Hot Water switch has been 

ON for more than 2 Min. 

Check: Dispense switches for proper 

operation or damage. Door harness 

for shorts.

44806.1 030612

Water Temp Too Hot

MENU

(-)

(+)

The water temperature in the tank 

exceeded 205°F (96°C).

Check: Tank heater harness for shorts, 

heater relay locked ON, heater element 

shorted to ground.