Brother XL-2600 Benutzeranleitung
Upper Threading 29
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Pulling up the bobbin thread
When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
first pull up the bobbin thread as described below.
1
Insert the bobbin into the shuttle.
• Refer to steps
• Refer to steps
1
through
5
2
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
Do not cut the thread with the cutter.
3
While lightly holding the upper thread with
your left hand, press
your left hand, press
(needle position
button) twice to raise the needle.
1 Needle position button
X
The bobbin thread is looped around the
upper thread and can be pulled up.
upper thread and can be pulled up.
4
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
out the end of the bobbin thread.
5
Pull out about 10-15 cm (3/8-5/8 inch) of the
bobbin thread under the presser foot toward
the rear of the machine.
bobbin thread under the presser foot toward
the rear of the machine.
6
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
2
1
S2_brotherE.book Page 29 Wednesday, May 14, 2003 8:05 PM