Brother VX-950 Benutzeranleitung
19
1
Drawing up the lower thread
a
Lightly hold the end of the upper thread.
a Upper thread
b
While holding the end of the upper thread,
raise the needle either by turning the
handwheel toward you (counterclockwise) so
that the mark on the wheel points up or by
pressing
raise the needle either by turning the
handwheel toward you (counterclockwise) so
that the mark on the wheel points up or by
pressing
(needle
position button) (for
models equipped with the needle position
button) once or twice.
button) once or twice.
c
Pull on the upper thread to draw up the lower
thread.
thread.
a Upper thread
b Lower thread
b Lower thread
d
Pull out about 10 cm (4 inch) of both threads
and pull them toward the back of the machine
under the presser foot.
and pull them toward the back of the machine
under the presser foot.
a Upper thread
b Lower thread
b Lower thread
■ For models equipped with the quick-set
bobbin
You can begin sewing immediately without
drawing up the bobbin thread. When sewing
gathers or darts, you can draw up the lower
thread by hand so that some thread will be left
over. Before you draw up the lower thread, put
the bobbin back in.
drawing up the bobbin thread. When sewing
gathers or darts, you can draw up the lower
thread by hand so that some thread will be left
over. Before you draw up the lower thread, put
the bobbin back in.
a
Pass the thread along the slit in the direction
of the arrow, and leave it there without
cutting it.
of the arrow, and leave it there without
cutting it.
• The bobbin cover should still be removed.
b
Draw up the lower thread as described in
steps 1 to 4.
steps 1 to 4.
c
Replace the bobbin cover.
a Mark
b Needle position button
or
NCBC2000.book Page 19 Thursday, October 21, 2004 4:32 PM