Brother Quattro 6000D Benutzeranleitung

English

Remove the material and re-thread in the correct
order, Lower looper, Upper looper, right needle
and then the left needle (to re-thread, see
CHAPTER 3 "Threading"). Replace the material
under the presser foot and sew 3-5 cm (1-1/8 to 2
inches) over the previous stitches.

Do not leave straight pins in the fabric when
sewing as they will damage the needles and
knives.

1. Adjust the presser foot pressure to prevent the

material from puckering and to allow sewing of
curves. (See CHAPTER 1 "Adjusting the
presser foot pressure".)

2. Loosen the thread tension, but remember that

if the tension is too loose, the thread may
break and stitches may be skipped.

The Narrow overlock/Rolled hemming stitch is a
decorative finish for lightweight to midweight
fabrics. It is often used to complete the edge of a
fabric. This stitch is sewn by removing the left
needle and using the 3-thread overlock stitch.

Turn off the main power and light switch before
removing/ installing a needle.

1. Remove the left needle.

NOTE:
For the recommended thread and needle, see
CHAPTER 4 "Sewing materials, threads, and
needles comparison chart".

2. Thread the machine for a three thread

overlock, using the right needle.

3. Remove the stitch finger <A>.

1 Raise the presser foot lever.
2 Pull all threads toward the back of the

machine.

3 Check to make sure that the thread is no

longer wrapped around the stitch finger.

4 Open the front cover.
5 Turn the hand wheel until the upperlooper

is at its lowest position.

6 Pull the stitch finger to the right and remove

it.

<A>