Biostar P4TGP 775 Benutzeranleitung
P
P
4
4
T
T
G
G
P
P
7
7
7
7
5
5
17
2.5 A
WARD
BIOS
BEEP CODE
Beep Meaning
One long beep followed by two short
beeps
beeps
Video card not f ound or video card
memory bad
memory bad
High-low siren sound
1. CPU overheated
2. System will shut down
2. System will shut down
automatically
One Short beep when system
boot-up
boot-up
No error found during POST
Long beeps ev ery other second
No DRAM detected or install
2.6 T
ROUBLESHOOTING
Probable Solution
1. No power to the system at all
Power light don’t illuminate, f an
inside power supply does not
turn on.
inside power supply does not
turn on.
2. Indicator light on key board does
not turn on.
1. Make sure power cable is
securely plugged in.
2. Replace
cable.
3. Contact technical support.
System inoperativ e. Keyboard lights
are on, power indicator lights are lit,
and hard driv e is spinning.
are on, power indicator lights are lit,
and hard driv e is spinning.
Using even pressure on both ends of
the DIMM, press down firmly until the
module snaps into place.
the DIMM, press down firmly until the
module snaps into place.
System does not boot from hard disk
driv e, can be booted f rom CD-ROM
driv e.
driv e, can be booted f rom CD-ROM
driv e.
1. Check cable running from disk to
disk controller board. Make sure
both ends are securely plugged
in; check the driv e type in the
standard CMOS setup.
both ends are securely plugged
in; check the driv e type in the
standard CMOS setup.
2. Backing up the hard drive is
extremely important. All hard
disks are capable of breaking
down at any time.
disks are capable of breaking
down at any time.
System only boots from CD-ROM.
Hard disk can be read and
applications can be used but booting
from hard disk is impossible.
Hard disk can be read and
applications can be used but booting
from hard disk is impossible.
1. Back up data and applications
f iles.
2. Ref ormat the hard driv e.
Re-install applications and data
using backup disks.
using backup disks.
Screen message says “Invalid
Conf iguration” or “CMOS Failure.”
Conf iguration” or “CMOS Failure.”
Rev iew system’s equipment. Make
sure correct inf ormation is in setup.
sure correct inf ormation is in setup.
Cannot boot system after installing
second hard driv e.
second hard driv e.
1. Set master/slave jumpers
correctly.
2. Run SETUP program and select
correct driv e types. Call the drive
manuf acturers f or compatibility
with other drives.
manuf acturers f or compatibility
with other drives.