Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Brother
  4. LS6233040
  5. Merkblatt

Brother LS6233040 Merkblatt

Download
Seite von 2
LS6233040
ARL/ASA/NZ
Printed in China
Before you can use the machine, read this Quick Setup Guide 
for the correct setup and installation.
Turn the sheet over.
Quick Setup Guide
DCP-385C
Install the ink cartridges
5
d. 
 Unpack the ink cartridge.
Turn the green knob on the protective yellow cap 
clockwise until it clicks to release the vacuum seal, 
then remove the cap 
a
.
If all lines are clear and visible, press    
(Yes) to finish the quality check. 
If you can see missing short lines, press     
(No) and follow the steps on the LCD.
o
o
Set the LCD contrast (If needed)
7
6
Check the print quality
c.  
Remove the green protective part 
a
.
OK
Poor
Set the date and time
8
a.  
Press Menu.
b.  
Press a or b to choose General Setup. 
press OK.
c.  
Press a or b to choose LCD Settings. 
press OK.
d.  
Press a or b to choose LCD Contrast.
e.  
Press d or c to choose Light, Med or Dark.
press OK.
f.   
Press Stop/Exit.
 Note
You can also adjust the angle of the display by 
lifting it.
a.  
Press Menu.
b.  
Press a or b to choose 
Initial Setup, and then press OK.
c.  
Press a or b to choose 
Date&Time, and then press OK.
b.  
Check the quality of the four colour 
blocks 
a
 on the sheet.
(black/yellow/cyan/magenta)
Unpack the machine and check the components
1
b. 
 Remove the green protective packing 
a
 
by lifting the front of the machine and then 
pulling down on the packing part.
c. 
 Remove the plastic bag 
b
 containing the ink 
cartridges from on top of the paper tray.
Plastic bags are used in the packaging of your machine. 
To avoid danger of suffocation, please keep these bags 
away from babies and children.
WARNING
d. 
 Fan the stack of paper well.
e.  
Gently put the paper into the 
paper tray. Check that the paper 
is flat in the tray.
f. 
Gently adjust the paper side 
guides to the paper with both 
hands. 
Make sure the paper side 
guides touch the edges of the 
paper.
g.  
Close the paper tray cover 
and slowly push the paper 
tray back into the machine.
h. 
 Pull out the paper support 
a
 until 
it clicks, and then unfold the paper 
support flap 
b
.
Important 
Do not push the paper 
in too far.
a. 
Connect the power cord. 
The machine must be fi tted with an earthed plug.
WARNING
Connect the power cord
3
e.  
Install each ink cartridge in the direction 
of the arrow on the label.
Take care to match the colour of the 
lever 
a
 with the cartridge colour 
b
.
Start Here 
 WARNING
Warnings tell you what to do to 
prevent possible personal injury.
Important
DO NOT 
connect the 
USB cable yet.
a.  
The LCD shows:
b. 
Open the ink cartridge cover 
a
. 
a.  
When the preparation process 
has finished, the LCD shows this 
message.
Press Colour Start.
 Note
The components of your box may differ depending on your 
country.
Save all packing materials and the box in case for any 
reason you must ship your machine.
Your machine has a USB interface that is compatible with 
the USB 2.0 specifi cation.
To ensure safe operation the supplied plug must be inserted 
only into a standard power outlet that is properly grounded 
through the standard electrical wiring. Non grounded 
equipment may cause an electrical shock hazard, and may 
cause excessive electrical noise radiation.
•
•
•
•
a. 
 Remove the protective tape and film.
Set the language (not available for Hong Kong users)
4
a.  
After connecting the power 
cord, the LCD shows: 
Press a or b to choose your 
language and press OK.
b.  
Choose Yes or No and press 
OK.
f. 
Gently push the ink cartridge until it clicks. After all the ink 
cartridges are installed close the ink cartridge cover.
d.  
Press a or b repeatedly to enter the last two digits of 
the year, and then press OK.
(e.g. Enter 08 for 2008.)
e. 
 Repeat for Month and Day, and Hours and Minutes 
in 24-hour format.
f. 
Press Stop/Exit.
Important
DO NOT connect the USB cable 
yet.
 Note
The control panel warning 
LED will stay on until you have 
installed the ink cartridges.
Important
After initial installation of the ink cartridges, the machine will start cleaning the 
ink tube system. This cleaning process will last approximately four minutes.
DO NOT unplug the machine from the power outlet or attempt to stop the 
cleaning process. Interruption of cleaning process may cause undesired print 
quality problems.
Australia & New 
Zealand
Hong Kong, 
Malaysia & 
Singapore
Philippines & 
Thailand
The supplied mains plug is a 
grounded three pin plug.
The supplied mains plug is 
a side grounded two pin plug.
d. 
Make sure you have all components.
2
Inbox Ink 
Cartridges [x4]
1
Black
Yellow
Cyan
Magenta
Power Cord
USB 
Interface 
Cable
CD-ROM
User’s Guide
Quick Setup 
Guide
 1
 Approx. 65% yield of the replacement cartridge. For details, see 
Consumable items in the User’s Guide.
 Note
The languages available may differ depending on your country.
If you set the wrong language, you can change it again after setting the 
date and time. (For details see Changing LCD language in Chapter 3 of the 
User’s Guide.)
•
•
 Note
If you make a mistake and want to start again, 
press Stop/Exit to go back to step a.
1
1
2
1
1
1
2
1
1
2
a. 
Pull out the paper tray.
b. 
Lift the paper tray cover 
a
.
Load plain A4 paper
c. 
 Press and slide the 
paper side guides 
a
 and 
paper length guide 
b
 to 
fit the paper size.
Make sure that the 
triangular marks 
c
 on 
the paper side guides 
a
 
and paper length guide 
b
 line up with the mark 
for the paper size you 
are using. 
1
1
3
3
2
11
Select Language
Select Language
Select & Press        OK 
Deutsch
Nederlands
Italiano
Français
English
English
Select Language
Select & Press        OK 
No
Yes
No Cartridge
Black
Install Ink
Set Paper and Press
Start
Date&Time
Year:20
08
MENU
Input & Press       OK