Benq Projector W1200 Benutzerhandbuch
Operation
39
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
following settings do not affect the projection settings, operation, or performance.
•
Menu display time in the SYSTEM SETUP > Menu Settings menu sets the length of time
the OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments. Use
the OSD will remain active after your last key press. The time length ranges from 5 to 30
seconds in 5-second increments. Use
/
to select a suitable time frame.
•
Menu position in the SYSTEM SETUP > Menu Settings menu sets the OSD position in
five locations. Use
five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP menu sets your familiar language for the OSD menus.
Use
Use
/
to select your language.
Shutting down the projector
1.
Press
Power and a confirmation message
displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
Power a second time. The POWER
indicator light flashes red, the projection lamp
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
•
To protect the lamp, the projector will not respond
to any commands during the cooling process.
to any commands during the cooling process.
3.
Once the cooling process finishes, the POWER indicator light is a steady red and fans
stop.
stop.
4.
Disconnect the power cord from the power putlet if the projector will not be used in
an extended period of time.
an extended period of time.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
•
Actual lamp life may vary due to different environmental conditions and usage.
I
I
I
I