Brother 5234PRW Benutzeranleitung

9

■ Front View

a Top cover

Open the top cover to thread the machine and wind the bobbin.

b Thread guide plate

Pass the thread around the thread guide plate when threading 
the upper thread.

c Thread take-up lever check window

Look through the window to check the position of the take-up lever.

d Needle threader lever

Use the needle threader lever when threading the needle 
automatically.

e Thread cutter

Pass the threads through the thread cutter to cut them.

f Flat bed attachment with accessory compartment

Store presser feet and bobbins in the accessory compartment 
of the flat bed attachment. Remove the flat bed attachment 
when sewing cylindrical pieces such as sleeve cuffs. 

g Operation buttons (5 buttons) and sewing speed 

Use these buttons to perform various operations, such as 
starting sewing and raising or lowering the needle. 
Slide the sewing speed controller to adjust the sewing speed 
while using utility stitches.

h Knee lifter slot

Insert the knee lifter into the slot.

i Knee lifter

Use the knee lifter to raise and lower the presser foot.

j LCD (liquid crystal display)

Stitch settings can be viewed and edited, and operations for 
using the machine can be displayed, and error messages 
appear in the LCD.

k Spool pin

Place a spool of thread on the spool pin.

l Spool cap

Use the spool cap to hold the spool in place.

m Bobbin winder

Use the bobbin winder when winding the bobbin.

n Supplemental spool pin

Use this spool pin to wind the bobbin thread while sewing or to 
sew with the twin needle.

o Thread guide

Pass the thread through this thread guide when winding the 
bobbin thread.

p Bobbin winding pretension disk and guide

Pass the thread through pretension disk and guide when 
winding the bobbin thread.

■ Right-side/Rear View

a Handle

When transporting the machine, carry it by this handle.

b Handwheel

Turn the handwheel toward you to sew one stitch or to raise or 
lower the needle.

c Embroidery card slot

Insert the embroidery cards (sold separately) into the 
embroidery card slot.

d USB port connector for media

In order to send patterns from/to USB media, plug the USB 
media into the USB port connector.

e USB port connector for computer

In order to import/export patterns between a computer and the 
machine, plug the USB cable into the USB port connector.

f Touch pen holder

Use the touch pen holder to hold the touch pen when it is not 
being used.

g Foot controller jack

Insert the plug on the end of the foot controller cord into the foot 
controller jack.

h Foot controller with retractable cord

Press the foot controller to control the speed of the machine.

i Jack connector

Insert the power cord into the connector jack.

j Main power switch

Use the main power switch to turn the machine ON and OFF.

k Air vent

Do not cover the air vent while the sewing machine is being 
used.

l Feed dog position switch

Use the feed dog position switch to lower the feed dogs.

m Presser foot lever

Raise and lower the presser foot lever to raise and lower the 
presser foot.