Benq PB8263 Benutzerhandbuch
Operation
37
Operating in a high altitude environment
We recommend you use the High Altitude Mode when your environment is higher than
3000 feet above sea level, or is hotter than 40
3000 feet above sea level, or is hotter than 40
°C
, or whenever the projector will be used for
extended periods of time (>10 hours) without shutdown.
To activate the High Altitude Mode, go to
Control > High Altitude Mode,
select On
by pressing
Left/
Right on the projector or remote control. A confirmation message
displays. Press AUTO.
Next time you turn on the projector, it will show a message pictured below as a reminder
during the start-up.
during the start-up.
Operation under "High Altitude Mode" may cause a higher decibel operating noise level
because of increased fan speed necessary to improve overall system cooling and
performance.
because of increased fan speed necessary to improve overall system cooling and
performance.
If you use this projector under other extreme conditions excluding the above, it may display
auto shut-down symptoms, which is designed to protect your projector from over-heating.
In cases like this, you should switch to High Altitude mode to solve these symptoms.
However, this is not to state that this projector can operate under any and all harsh or
extreme conditions.
auto shut-down symptoms, which is designed to protect your projector from over-heating.
In cases like this, you should switch to High Altitude mode to solve these symptoms.
However, this is not to state that this projector can operate under any and all harsh or
extreme conditions.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
following settings do not affect the projection settings, operation, or performance.
•
OSD Time in the Control > OSD menu sets the length of time the OSD will remain
active after your last button press. The time length ranges from 5 to 60 seconds in 5-
second increments.
active after your last button press. The time length ranges from 5 to 60 seconds in 5-
second increments.
•
Language in the Control menu sets your familiar language for the OSD menus. Use
Left/
Right on the projector or remote control to select your language.
•
User Logo in the Control > Setup menu allows you to set a preferred logo screen to be
displayed during projector start-up.
displayed during projector start-up.
We recommend you use the High Altitude Mode by selecting On
when your environment is higher than 3000 feet, or is hotter than 40°C.
Do you want to turn on High Altitude Mode?
Yes Auto No
Current Status
High Altitude Mode On
This mode is used for protecting projector from extreme environment and may cause high
fan speed.