Benq PB8263 Benutzerhandbuch
Maintenance
52
7.
Re-install the lamp cover and tighten the
screws.
screws.
8.
Make connection to a signal source to be
displayed. Start up the projector. (See page
displayed. Start up the projector. (See page
for turning the power on.)
•
Do not turn the power on with the lamp cover
removed. Whenever the lamp is replaced,
reset the total lamp operation timer.
removed. Whenever the lamp is replaced,
reset the total lamp operation timer.
•
Do not reset if the lamp is not replaced as this
could cause damage.
could cause damage.
9.
Reset the lamp counter
i. Press and hold
Exit on the
projector for 3 seconds to display
the total used lamp time.
the total used lamp time.
ii. Press
Menu on the projector or
MENU on the remote control to
access the lamp hour timer. An
adjustment message will display.
access the lamp hour timer. An
adjustment message will display.
iii. Press
Left/
Right on the
projector or remote control to
reset lamp hours and press
reset lamp hours and press
Exit to leave.
Temperature information
When the Temperature warning light is on, it is warning you of the following possible
problems.
problems.
1.
The internal temperature is too high.
2.
Dust filters are clogged.
3.
The fans are not working.
Turn the projector off, check that the dust filters are clean. If the problem persists, contact
qualified service personnel for further help.
qualified service personnel for further help.