Global Upholstery Co. Mini-ITX 2807840 Benutzerhandbuch

CPU L2 Cache - The flash memory inside the CPU, normally Pentium III CPU has 256K or
above, while Celeron CPU will have 128K.

2-3-1 Setting CPU Bus Clock & Memory Clock Jumper

Setting the front side bus frequency and SDRAM frequency

The motherboard uses jumper less function for the front side bus frequency and SDRAM
frequency users don’t need setting any jumper when plug the CPU in motherboard

For experience user looking for over clocking possibility, please refer to sec 2-3-2.

2-3-2 Over clock Running

WARNING! This section is for experienced motherboard installer only. Over clocking

can result in system instability or even shortening life of the processor.

Users can choose over clock running by BIOS CMOS SETUP UTILITY. When you entered
CMOS SETUP UTILITY, choose “Miscellaneous Control” you will see the screen as below
then.

Phoenix – AwardBIOS CMOS Setup Utility

Miscellaneous Control

Item Help

Auto Detect PCI Clock Enabled

Spread Spectrum Disabled

** Current Host Clock 100MHZ

Host Clock at Next Boot 100MHZ

** Current DRAM CLOCK 266MHz **

DRAM Clock at Next Boot 266MHz(By SPD)

VDIMM Select 1.90V(Default)

VAGP Select 1.55V(Default)

Flash Part Write Protect Disabled

Menu  Level  >

↑↓→← Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Previous Values F6:Optimized Defaults F7:Standard Defaults

WARNING! The Design of this motherboard follows chipset and CPU vender’s design

guideline. Any attempts to push beyond product specification are not
recommended and you are taking your own risk to damage your system or
important data. Before over clocking, you must make sure your
components are able to tolerate such abnormal setting, especially CPU,
memory, hard disks, and VGA cards.