Gaggenau gaggenau refigerator rc 462/413 rf 411/413 rf 461/463 rf 471 rw 414/464 Benutzerhandbuch

Note:
To ensure that the appliance functions correctly, it must 

be set perfectly levelled.

The positioning aid on the door have been designed for 

the following total thickness of door panels:
–

3

/

4

" (19 mm)

–

1

1

/

2

" (38 mm)

Always take account of the possible differing thickness of 

the panel fronts which are to be fitted subsequently.
1. Align the appliance with the cabinet fronts using the 

positioning aid.
Place level over the positioning aid on the door.

Notes:
–

Do not twist or jam the appliance inside the 

installation niche! When adjusting the height-

adjustable feet, proceed gradually: Always alternate 

between left and right, etc.

–

For easier adjustment of the rear feet take the weight 

off by slightly tilting the appliance forward.

–

When using a wooden beam as an alternative anti-tip 

mechanism, turn the appliance as far as it will go 

against the wooden beam. Do not bend against the 

wooden beam.

The height-adjustable feet at the front and rear can all be 

adjusted from the front.
Front:

with open-ended wrench 

1

/

2

" 

(Width across flats 13 mm)

Rear:

with 

5

/

16

" (8 mm) hex nut driver via flexible 

shaft. 

The mark (a) attached at the appliance base is used as 

a standard gage for height adjustment. When adjusting 

the height, align this mark at a height of 1

1

/

2

" (32 mm) 

above the floor.
It is very important to comply with this dimension for the 

subsequent alignment of the furniture fronts.

The height adjustment gauge (b) is used 

to set this height correctly. The upper 

edge of the gauge must be in alignment 

with the mark on the appliance. 

2. Unscrew the feet at the front of the appliance until the 

mark (a) on the appliance is in alignment with the 

upper edge of the height adjustment gauge (b).

3. Align the appliance vertically using the feet 

at the back. Use a level!