Equinox Systems Convertor RS232-RS485 Benutzerhandbuch

 

• 

Place the PRO104/108 programmer(s) on a flat surface allowing sufficient space in front 
of each programmer to place the ‘ISP Interface Modules’ and ‘Target Systems’. 

• 

Plug the 9-way RS-232 cable into the port on the RS-232 to RS-485 convertor. 

 

 

• 

Plug an RS-485 network cable from one of the RS-485 outputs on the RS-485 convertor 
to the ‘RS-485 Input’ connector on the rear panel of the first PRO104. 

• 

Plug another RS-485 network cable from the ‘RS-485 Output’ connector on the rear 
panel of the first PRO104/108 to the next PRO104/108 in the chain. 

• 

A return RS-485 cable from the last PRO104/108 in the chain to the RS-485 convertor is 
NOT required. 

• 

Power up the PC 

• 

Power up the PRO104/108 programmer(s) 

• 

Launch the ISP-PRO software on the PC and set up the required number of PPM’s 
within the software 

• 

Test that all PPM’s are communicating with the PC at their correct ‘Node Address’. (The 
Node Address may be changed while the programmer is powered up).