Epson Multi-mode Data Controller MFJ-1278B Benutzerhandbuch

This pin is tied to the SIO receive clock input pin.  It expects a clock at the desired data rate 
(1200 Hz for 1200 baud), of the proper phase relationship to the received data.  This pin is 
normally jumpered to pin 14 when the on-board modem is used. 
 
Pin 14 Receive Clock Output 

This pin is the received data clock signal derived from the NRZI-to-NRZ state machine.  This 
pin is normally jumpered to pin 13 when the on-board modem is used. 
 
Pin 15 MFJ-1278B  Ground Reference 

This pin ties to the MFJ-1278B digital ground system, at the SIO. 
 
Pin 16 Turbo LED output 

This pin is used to connect the Turbo LED on the mother board to the external modem board.  
When this pin is high (+5Vdc), the Turbo LED will light. 
 
Pin 17 Receive Data Input 

This pin is the received data input to the NRZI-to-NRZ state machine.  This pin is normally 
jumpered to pin 18 when the on-board modem is used. 
 
Pin 18 Receive Data Output 

This pin provides receive data from the on-board modem.  This pin is normally jumpered to 
pin 17 when the on- board modem is used. 
 
Pin 19 Transmit Data Output 

This line is the NRZ or NRZI (depending on the state of JMP11) data output.  This pin is 
normally jumpered to pin 20 when the on-board modem is used. 
 
Pin 20 Transmit Data Input 

This input line accepts data to be be transmitted by the modem.  This pin is normally 
jumpered to pin 19 when the on-board modem is used. 
 
If you elect to use an off-board modem, be sure to properly shield the interconnecting cables 
for RFI protection. 

The MFJ-1278B has a built-in tuning indicator for HF operation.  It is set for a center 
frequency of 2210 Hz.  The incoming audio frequency is centered at 2210 Hz.  This is