Epson Multi-mode Data Controller MFJ-1278B Benutzerhandbuch
MFJ-1278B MULTI-MODE BASIC OPERATION
GETTING STARTED
This chapter will guide you through the basic operation on all the modes that the MFJ-1278B
is capable of performing. It contains the basic information required to operate PACKET,
PACTOR, RTTY, ASCII, CW, AMTOR, NAVTEX, FAX, SSTV and CW Memory Keyer.
Note: In this section you will see this symbolism, <ENTER>. This means to press the
is capable of performing. It contains the basic information required to operate PACKET,
PACTOR, RTTY, ASCII, CW, AMTOR, NAVTEX, FAX, SSTV and CW Memory Keyer.
Note: In this section you will see this symbolism, <ENTER>. This means to press the
Carriage Return or Enter key on your keyboard.
First Steps
1.
Make sure that your computer is connected to the RS-232C port or the TTL port on the
MFJ-1278B according to Chapter 2.
MFJ-1278B according to Chapter 2.
2.
Make sure that your radios are connected to the MFJ-1278B according to Chapter 3.
3.
Turn on your computer. Load and run the terminal program.
4.
Turn on the MFJ-1278B. The MFJ-1278B will sign on with "cmd:" prompt sign. If the
MFJ-1278B fails to sign-on, press the return key on your computer a few times in
succession, the MFJ-1278B will sign-on as as follow:
MFJ-1278B fails to sign-on, press the return key on your computer a few times in
succession, the MFJ-1278B will sign-on as as follow:
*:J
bbRAM:LOADED WITH DEFAULTS
|A
MFJ ENTERPRISES, INC.
MODEL MFJ-1278B
AX.25 Level 2 Version 2.0
Release XXXXX (date) - XX K RAM
Checksum XXX
cmd:
bbRAM:LOADED WITH DEFAULTS
|A
MFJ ENTERPRISES, INC.
MODEL MFJ-1278B
AX.25 Level 2 Version 2.0
Release XXXXX (date) - XX K RAM
Checksum XXX
cmd:
Note: The "|A" may display as a vertical-bar and any capital letter from "A" through "J".
The first five lines are the sign-on message, which you will normally see only when you
power up the MFJ-1278B. The Command Mode prompt, cmd: will appear when the MFJ-
1278B is in Command Mode. The cmd: prompt indicates that he MFJ-1278B is now ready
to accept your instructions. Upon sign-on the MFJ-1278B is in the VHF packet mode.
Before the MFJ-1278B can be fully operational, some of the basic parameters must be set.
The first five lines are the sign-on message, which you will normally see only when you
power up the MFJ-1278B. The Command Mode prompt, cmd: will appear when the MFJ-
1278B is in Command Mode. The cmd: prompt indicates that he MFJ-1278B is now ready
to accept your instructions. Upon sign-on the MFJ-1278B is in the VHF packet mode.
Before the MFJ-1278B can be fully operational, some of the basic parameters must be set.
Basic Commands
With the MFJ-1278B signed-on and in the VHF packet mode, you are ready to start setting
up the basic commands you will use. The commands in the MFJ-1278B are set to their
defaults. Some of these defaults may be sufficient for the way you wish the MFJ-1278B to
up the basic commands you will use. The commands in the MFJ-1278B are set to their
defaults. Some of these defaults may be sufficient for the way you wish the MFJ-1278B to