Whirlpool WFG510S0AW Anleitung Für Quick Setup

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

Check that all parts are included. 

■

Anti-tip bracket must be securely mounted to floor or wall. 
Thickness of flooring may require longer screws to anchor 
bracket to floor.

Check local codes and consult gas supplier. Check existing gas 
supply and electrical supply. See “Electrical Requirements” and 
“Gas Supply Requirements” sections.

IMPORTANT: Observe all governing codes and ordinances. Do not 
obstruct flow of combustion and ventilation air. 

■

It is the installer’s responsibility to comply with installation 
clearances specified on the model/serial rating plate. The 
model/serial rating plate is located on the oven frame behind 
the top left side of the oven door.

■

Recessed installations must provide complete enclosure of the 
sides and rear of the range.

■

All openings in the wall or floor where range is to be installed 
must be sealed.

■

Do not seal the range to the side cabinets.

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions are minimum clearances.

■

The anti-tip bracket must be installed. To install the anti-tip 
bracket shipped with the range, see “Install Anti-Tip Bracket” 
section.

■

Grounded electrical supply is required. See “Electrical 
Requirements” section. 

■

Proper gas supply connection must be available. See “Gas 
Supply Requirements” section.

■

Contact a qualified floor covering installer to check that the 
floor covering can withstand at least 200°F (93°C). 

■

Use an insulated pad or ¼" (0.64 cm) plywood under range if 
installing range over carpeting.

IMPORTANT: To avoid damage to your cabinets, check with your 
builder or cabinet supplier to make sure that the materials used will 
not discolor, delaminate or sustain other damage. This oven has 
been designed in accordance with the requirements of UL and CSA 
International and complies with the maximum allowable wood 
cabinet temperatures of 194°F (90°C).

■

Tape measure

■

Flat-blade screwdriver

■

Phillips screwdriver

■

Level

■

Hand or electric drill

■

Hammer

■

Wrench or pliers

■

Pipe wrench

■

¹⁵⁄₁₆" combination wrench

■

¼" drive ratchet

■

³⁄₈" nut driver

■

¹⁄₈" (3.2 mm) drill bit (for 

wood floors)

■

Marker or pencil

■

Pipe-joint compound 
resistant to LP gas

■

Noncorrosive leak-detection 
solution

■

³⁄₈" combination wrench

■

½" combination wrench

■

⁵⁄₈" combination wrench

■

7 mm (

⁹⁄₃₂") nut driver 

■

Quadrex

®†

 or Phillips 

screwdriver

■

Masking tape

⁵⁄₈

A

B

†® QUADREX is a registered trademark of NLW Holdings, Inc.