Whirlpool W10200356B Benutzerhandbuch

Seite von 12
6
OVEN USE
Odors and smoke are normal when the oven is used the first few 
times, or when it is heavily soiled.
IMPORTANT: The health of some birds is extremely sensitive to the 
fumes given off. Exposure to the fumes may result in death to 
certain birds. Always move birds to another closed and well-
ventilated room.
Electronic Oven Controls
Control Display
The display will flash when powered up or after a power loss. Press 
CANCEL/OFF to clear. When oven is not in use the time of day is 
displayed. Indicator lights show functions that are in use.
Tones
Tones are audible signals, indicating the following:
Basic Functions
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder (on some models), repeating each minute after the 
end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to 
Celsius. 
To change: Press and hold BROIL for 5 seconds. A tone will 
sound, and “°C” or “°F” will appear on the display. Repeat to 
change back. 
To exit mode, press CANCEL/OFF.
Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven 
temperature because opening the oven door may cause element 
cycling to give incorrect readings.
The oven provides accurate temperatures; however, it may cook 
faster or slower than your previous oven, so the temperature 
calibration can be adjusted. It can be changed in Fahrenheit or 
Celsius.
To Adjust Oven Temperature Calibration:
1. Press and hold BAKE for 5 seconds until the oven display 
shows the current calibration, for example “0°F CAL” or “00.”
2. Press the TEMP/TIME “+” or “-” arrow pads to increase or to 
decrease the temperature in 10°F (5°C) amounts. The 
adjustment can be set between 30°F (15°C) and -30°F (-15°C).
3. Press START.
Options Mode
Press and hold TIMER for 5 seconds and “Opt” will appear. Use the 
TEMP/TIME keys to cycle through the following options. Press 
CANCEL to exit the mode.
End of Cycle Tones
“b1” (beep once) or “b” (continue to beep) will be displayed. Press 
TIMER to toggle through selection.
12-Hour Shutoff
If “12 Hr” is displayed the oven will automatically shut off after 
12 hours. Press TIMER to toggle to “- Hr” to disable the 12-hour 
shutoff.
Oven Light with Door Open
“LOn” indicates that the oven light will turn on when the door is 
open. If “LOFF” is displayed the oven light will turn on only with the 
oven light switch. Press TIMER to toggle through selection.
Aluminum Foil
IMPORTANT: To avoid permanent damage to the oven bottom 
finish, do not line the oven bottom with any type of foil, liners or 
cookware.
For best cooking results, do not cover entire oven rack with foil 
because air must be able to move freely.
Positioning Racks and Bakeware
IMPORTANT: To avoid permanent damage to the porcelain finish, 
do not place food or bakeware directly on the oven door or bottom.
Bakeware
To cook food evenly, hot air must be able to circulate. Allow 
2" (5 cm) of space around bakeware and oven walls. Make sure 
that no bakeware piece is directly over another.
Racks
Position racks before turning on the oven. 
Do not move racks with bakeware on them. 
Make sure racks are level. 
To move a rack, pull it out to the stop position, raise the front edge, 
and then lift out. Use the following illustration and charts as a 
guide.
Rack Positions
Rack 5: Toasting bread or broiling thin, non-fatty foods.
Rack 4: Use for 2-rack baking and broiling.
Rack 3: Most baked goods on a cookie sheet or jelly roll pan, layer 
cakes, frozen convenience foods. Broiling chicken pieces.
1
2
3
4
5