Whirlpool 9763003 Benutzerhandbuch

■

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

■

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Is the “Cooktop Lockout” set?
See “Cooktop Lockout” section.

■

Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.

■

Are the burner ports clogged? 
See “Sealed Surface Burners” section.

■

On models with caps, are the burner caps positioned 
properly?
See “Sealed Surface Burners” section.

■

Is propane gas being used?
The appliance may have been converted improperly.    
Contact a service technician or see “Assistance or Service” 
section.

■

Is the burner wet?
Let it dry.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the control knob set to the proper heat level?
See “Cooktop Controls” section.

■

Is the appliance level?
Level the appliance. See the Installation Instructions.

■

Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the electronic oven control set correctly?
See “Electronic Oven Control” section.

■

On some models, is the Control Lockout set?
See “Control Lockout” section.

■

Is propane gas being used?
The appliance may have been converted improperly. Contact 
a service technician or see “Assistance or Service” section.

■

It is normal for the fan to automatically run while the oven is in 
use to cool the electronic control.

■

Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

■

Is the display showing “PF” or a flashing time?
There has been a power failure. Clear the display. See 
“Display(s)” section. On some models, reset the clock, if 
needed. See “Clock” section.

■

Is the display showing a letter followed by a number?
Depending on your model, press OFF/CANCEL, OFF or 
CANCEL/OFF to clear the display. See “Display(s)” section. If 
it reappears, call for service. See “Assistance or Service” 
section.

■

Is the oven door open?
Close the oven door all the way.

■

Has the function been entered?
See “Self-Cleaning Cycle” section.

■

On some models, has a delay start Self-Clean cycle 
been set?
See “Self-Cleaning Cycle” section.

■

Has a delay start been set?
See “Timed Cooking” section.