Brother CP-7500 Benutzeranleitung
148
EMBROIDERY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Thread runs out partway
through a design
through a design
When the upper thread or the bobbin thread runs out
while sewing, the sewing machine stops. Move the
needle back about 10 stitches and resume sewing.
while sewing, the sewing machine stops. Move the
needle back about 10 stitches and resume sewing.
Memo
z When the bobbin thread runs out, cut the
threads and remove the embroidery frame
before replacing the bobbin thread.
before replacing the bobbin thread.
a
Set up the upper or bobbin thread.
b
Press
.
Memo
z If the needle count is not displayed, display
the needle count on the screen. For details,
refer to "Stopping while embroidering" (page
148).
refer to "Stopping while embroidering" (page
148).
c
Press .
d
Press
(Back one stitch) to move the
needle back about 10 stitches.
(Forward one stitch) increases the stitch
number.
e
Restart the embroidery.
Stopping while embroidering
If the embroidery is stopped before it is complete,
check the current needle count and layout before
turning off the sewing machine.
check the current needle count and layout before
turning off the sewing machine.
Memo
z When the sewing machine is turned off, the
embroidery size and layout return to the
original setting. If you have changed the
layout, you need to adjust it again.
original setting. If you have changed the
layout, you need to adjust it again.
a
Press
(Start/stop button) to stop the
sewing machine.
b
Check the current needle count on the screen
and make a note of it.
and make a note of it.
If the needle count is not displayed, press
(Settings key), and then use
to
display the following screen.
Press
to return to the previous screen.
c
Press
(Embroidery key).
X
The confirmation message is displayed.