Woodstock W1680 Benutzerhandbuch
Figure 20. Seating arbor into spindle.
-15-
A wedge is included with the Shop Fox
®
Drill
Press which aids in drill chuck arbor removal.
1.
Rotate the spindle handles until a slot is
exposed in the side of the quill.
exposed in the side of the quill.
2.
Rotate the spindle until the inner slot is
aligned with the outer. See Figure 21. You
will see through the spindle when slot is
properly aligned.
aligned with the outer. See Figure 21. You
will see through the spindle when slot is
properly aligned.
3.
Insert the wedge into the slot and allow
quill to rise, trapping the wedge. Hold the
drill chuck with one hand and tap on the
wedge with a hammer. See Figure 22.
quill to rise, trapping the wedge. Hold the
drill chuck with one hand and tap on the
wedge with a hammer. See Figure 22.
Arbor Removal
Figure 21. Inner and outer slots aligned.
Figure 22. Using wedge to remove arbor.
Wear safety glasses when
removing drill chuck
from spindle. Failure to
comply may result in
serious personal injury.
removing drill chuck
from spindle. Failure to
comply may result in
serious personal injury.
ASSEMBLY
4.
Slide the arbor into the spindle socket while
slowly rotating drill chuck. The socket has a
rectangular pocket in which the tang (or flat
portion of the arbor) fits into. Once the tang
is oriented correctly the drill chuck will not
rotate without turning the spindle.
slowly rotating drill chuck. The socket has a
rectangular pocket in which the tang (or flat
portion of the arbor) fits into. Once the tang
is oriented correctly the drill chuck will not
rotate without turning the spindle.
5.
Tap the end of the drill chuck with a rubber
or wooden mallet to seat the drill chuck.
See Figure 20.
or wooden mallet to seat the drill chuck.
See Figure 20.