Bracketron MVM Multi Vehicle Mount MVM-45-05 Benutzerhandbuch
IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-
tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles
dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED: MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop
Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware.
TOOLS NEEDED FOR MVM MODIFICATION (if required)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Standard Hacksaw
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
Two Sets of Audi Radio Removal Tools (Part #SIT-102)
5/16” Socket and Drive
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Locate the four slots on the face of the radio. Insert the Audi DIN tools in
these four slots until you hear a click or lock. Note: There is a rubber
seal that wraps around the radio between the radio and the dash pad.
This causes the radio to sit very tightly in the cavity. To loosen this seal
and allow the radio to slide out easier, we recommend using a Dash Trim
Tool to wedge between both the right and left sides of the radio dash
pad. Carefully wiggle the tool to loosen the radio slightly.
Grasp the four DIN tools and slide the radio out of its cavity just enough
to allow access to the one (1) 5/16” hex head bolt that holds the climate
control in place. Caution: Do not disconnect the radio. You will need the
radio code to re-program it. Place a clean cloth over the shifter knob. Set
the radio on the shifter knob so it is out of the way.
Skip to Step 5 on the following page if you have not yet formed the
bracket to fit your vehicle.
Remove the top right 5/16” hex head bolt that holds the climate con-
trol in place. Place the mount over the screw hole. Replace the bolt and
tighten with the 5/16” socket and driver.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Remove Bolt