Whirlpool Range W10459123B Benutzerhandbuch

1. Open the oven door and remove oven racks, oven tray, and 

flame spreader and set aside.

2. Lift oven burner. The orifice spud is behind the oven burner 

air shutter.

3. Locate Natural gas orifice spud stamped “51” in the package 

containing literature supplied with the range.

4. Use a 

³⁄₈" combination wrench and remove the LP gas orifice 

spud.

5. Install the number “51” LP gas spud.

IMPORTANT: Do not overtighten.

6. Place LP gas oven burner spud in plastic parts bag along 

with LP gas cooktop burner spuds for future use and keep 
with the bag containing literature.

7. Reinstall oven burner.

8. Reinstall oven racks, oven tray and flame spreader.

1. Refer to the “Make Gas Connection” section for properly 

connecting the range to the gas supply.

2. Turn the manual shutoff valve in the gas supply line to the 

“open” position.

3. Refer to “Check Operation of Cooktop Burners” in the 

“Electronic Ignition System” section for proper burner 
ignition, operation and burner flame adjustments.

IMPORTANT: You may have to adjust the “Lo” setting for 
each cooktop burner.

Checking for proper cooktop and oven burner flames is very 
important. The small inner cone should have a very distinct 
blue flame ¼" to ½" (0.6 cm to 1.3 cm) long. The outer cone 
is not as distinct as the inner cone. Natural gas flames do not 
have yellow tips.

4. Close the oven door and turn the knob to the “OFF” position.

5. Refer to the “Complete Installation” section to complete this 

procedure.

B

A

A

© 2012 Whirlpool Corporation.
All rights reserved.

8/12

Printed in Mexico