Whirlpool TEP315RV1 Benutzerhandbuch

4. Pull door straight up, then toward you. Hinge hangers will 

slide out of front frame hinge slot. Do not remove door 
removal pins until the door is replaced on the range.

1. Grasp the door on the sides with your fingers on the front of 

the door and your thumbs on the inside surface.

2. Hold oven door so that the top edge of each hinge hanger is 

horizontal. Insert hinge hangers into the front frame hinge 
slots.

3. Tilt top of door toward range. Slide hinge hangers down onto 

front frame support pins. Make sure the hinge hangers are 
fully seated and engaged on the support pins.

4. Insert the door stop clip with the angular surface at the top of 

the frame hinge slot, then push in the bottom of the clip until 
flanges are flush with the front frame.

5. Open the door completely and remove the door removal pins. 

Save door removal pins for future use.

6. Close the door.

The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.

1. Pull the storage drawer straight back past the drawer stop 

notch and the end of the side rails.

2. Lift up the back of the drawer and pull the drawer out.

1. Lift up the back of the drawer and place it inside the range in 

its fully forward position.

2. Lift up the front of the drawer to a level position.

3. Slowly push the drawer into the range until the drawer side 

rails engage with the gap in the drawer glides.

4. Once the drawer is fully engaged on both sides, slide the 

drawer back into the closed position. 

NOTE: When removing and replacing the storage drawer, a 
slight push may be needed to move the drawer stop notch 
past the drawer glides.

■

Is the power supply cord unplugged?
Plug into a grounded outlet.

■

Has a household fuse blown, or has a circuit breaker 
tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

On ceramic glass models, is the “Cooktop Lockout” set?
See “Cooktop Lockout” section.

■

On coil element models, is the element inserted properly?
See “Coil Elements and Burner Bowls” section.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

■

Does the Hot Surface indicator light stay on after control 
knob(s) have been turned off?
See “Cooktop Controls” section.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the control knob set to the proper heat level?
See “Cooktop Controls” section.

■

Is the appliance level?
Level the appliance. See the Installation Instructions.

A

B

A