Whirlpool 9757455A Benutzerhandbuch

■

Is the power supply cord unplugged?
Plug into a properly grounded 3 prong outlet.

■

Has a household fuse blown, or has a circuit breaker 
tripped?
Replace the fuse or reset the circuit.

■

Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” 
section.

■

Are the burner ports clogged? 
On sealed burner models, see “Sealed Surface Burners” 
section.

■

On models with caps, are the burner caps positioned 
properly?
See “Sealed Surface Burners” section.

■

Is propane gas being used?
The appliance may have been converted improperly.    
Contact a trained repair specialist.

■

Is the burner wet?
Let it dry.

■

Is there continuous sparking, but the burner does not 
light?
Discontinue use of the surface burner and contact a service 
technician.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than 1" (2.5 cm) outside the cooking area.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the control knob set to the proper heat level?
See “Cooktop Controls” section.

■

Is the appliance level?
Level the appliance. See the Installation Instructions.

■

Is this the first time the oven has been used?
Turn any one of the surface burner knobs on to release air 
from the gas lines.

■

Is the electronic oven control set correctly?
See “Electronic Oven Control” section.

■

On some models, is the Control Lock set?
See “Control Lock” section.

■

Is propane gas being used?
The appliance may have been converted improperly. Contact 
a trained repair specialist.

■

It is normal for the fan to automatically run while the oven is in 
use to cool the electronic control.

■

Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

■

Is the display showing “PF,” “PF id=27” or “PF id=30”?
There has been a power failure. Clear the display. See 
“Display” section. On some models, reset the clock if 
needed. See “Clock” section.

■

Is the display showing a letter followed by a number?
Clear the display. See “Display” section. If it reappears, call 
for service. See “Service or Assistance” section.

■

Is the oven door open?
Close the oven door all the way.

■

Has the function been entered?
See “Self-Cleaning Cycle” section.

■

On some models, has a delay start Self-Clean cycle been 
set?
See “Self-Cleaning Cycle” section.

■

Has a delay start been set?
See “Timed Cooking” section.