Whirlpool GY399LXUB Anleitung Für Quick Setup

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that 
the ground path is adequate and wire gauge are in accordance 
with local codes.

Be sure that the electrical connection and wire size are adequate 
and in conformance with CSA Standard C22.1, Canadian 
Electrical Code, Part 1 - latest edition, and all local codes and 
ordinances.

A copy of the above code standards can be obtained from:

Canadian Standards Association

178 Rexdale Blvd.

Toronto, ON M9W 1R3 CANADA

■

Check with a qualified electrical installer if you are not sure 
the range is properly grounded.

*The NEC calculated load is less than the total connected load 

listed on the model/serial/rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord with 

kit. For 50-amp rated cord kits, use kits that specify use with a 
nominal 1

³⁄₈" (34.9 mm) diameter connection opening.

■

A time-delay fuse or circuit breaker is recommended.

■

This range is equipped with a CSA International Certified 
Power Cord intended to be plugged into a standard 14-50R 
wall receptacle. Be sure the wall receptacle is within reach of 
range’s final location.

■

Do not use an extension cord.

The cooktop sides of the slide-in range fit over the cutout edge of 
your countertop.

If you have a square finish (flat) countertop and the opening width 
is 30" (76.2 cm), no countertop preparation is required.

Formed front-edged countertops must have molded edge 
shaved flat 

³⁄₈" (1.0 cm) from each front corner of opening.

Tile countertops may need trim cut back 

³⁄₈" (1.0 cm) from each 

front corner and/or rounded edge flattened. 

If countertop opening width is greater than 30" (76.2 cm), adjust 
the 

³⁄₈" (1.0 cm) dimension.

Countertop must be level. Place level on countertop, first side to 
side, then front to back. If countertop is not level, range will not 
be level. Range must be level for satisfactory baking conditions.

1. Remove shipping materials, tape and film from the range. 

Keep cardboard bottom under range.

2. Remove oven racks and parts package from inside oven.

3. Pull storage drawer out completely.

4. Remove and discard cardboard cross support.

8.8 - 16.5 KW
16.6 - 22.5 KW

7.8 - 12.5 KW
12.6 - 18.5 KW

40 or 50**
50

A

B