BlueAnt Wireless Interphone none Benutzeranleitung

Using the Headset Clip Mount with Adhesive  

1.  Before removing the protective strip from the double-sided adhesive, find 

the best location to place the Headset Clip Mount.  

2.  Clean the part of the helmet that the Headset Clip Mount with Adhesive will 

be attached to. Remove any dirt or grease. Do not use cleaners that may 
damage the helmet or that will leave an oily residue. Make sure the surface 
is dry before continuing. 

3. Check again the positioning of the clip. Once it is mounted it will not be 

possible to move without making the 
adhesive unusable. So please take care 
when choosing its position.  

4.  Note that the small section of the two 

holes/slots in the Clip must be faced 
towards the bottom of the helmet. As 
shown in the picture to the right. 

5.  Remove the protective strip from the 

double-sided adhesive and carefully 
attach the Clip to the outside shell of the 
helmet.   

 
 

 

 
1.  Take your InterPhone 

Headset and slide it down 
into the slots in the 
Headset Clip Mount. 
Make sure that it’s 
perfectly fitted and locked 
into place by trying to 
extract it, pulling upwards.  

 

 
2.  Now you need to attach the 

speaker and microphone 
arm to the inside of the 
helmet. Take the Velcro 
pad which the speaker will 
attach to, and test for the 
best position to fix it. The 
Velcro Pad should be fixed 
at the height of your ear in the helmets ear pocket.  You will need to put the 
helmet on a few times to find the optimum position to apply the pad. When the 
correct positioning is found, remove the protective strip and apply the Velcro 
Pad. 

 

5