Bravetti EP865 Benutzerhandbuch
Read all the sections of this booklet and follow all the instructions carefully.
Before Using for the First Time
This appliance is designed for indoor/outdoor use. It is a stand-alone barbecue grill or griddle.
Do not use charcoal, lighter fuel or gases with this appliance.
Do not use charcoal, lighter fuel or gases with this appliance.
Carefully unpack the Griddle/Grill/Roaster and remove all the packing materials. Wipe the
surfaces with a clean, damp cloth or sponge, then dry with another cloth. This will remove any
dust that may have settled during packaging. If desired, apply a thin coat of cooking oil or
cooking spray on the griddle/grill surface to facilitate in cooking and clean-up during next use.
surfaces with a clean, damp cloth or sponge, then dry with another cloth. This will remove any
dust that may have settled during packaging. If desired, apply a thin coat of cooking oil or
cooking spray on the griddle/grill surface to facilitate in cooking and clean-up during next use.
Set the Griddle/Grill/Roaster on a clean, dry counter or sturdy table away from an open flame or
hot burners.
hot burners.
CAUTION:
Do not immerse the main unit, temperature control and power
cord in water or any other liquid.
cord in water or any other liquid.
CAUTION: Use only with the temperature control provided with the
GRIDDLE/GRILL/ROASTER
WARNING:
The sides and bottom of the griddle/grill/roaster get very warm. It is
recommended that you use an insulated hot pad underneath the unit to
avoid any heat damage to your counter or furniture. Also, always use
oven mitts when opening or closing the roll-back lid cover.
recommended that you use an insulated hot pad underneath the unit to
avoid any heat damage to your counter or furniture. Also, always use
oven mitts when opening or closing the roll-back lid cover.
PLEASE NOTE: The unit may make a “Creaking” noise during preheating
and at different times as it maintains the set temperature.
This is normal and is due to the expansion of the parts
during the heating process.
This is normal and is due to the expansion of the parts
during the heating process.
2