Westcott Halo & Apollo 1050 Merkblatt
Light Modifiers
Page 1 of 1
Questions? Please call 800.886.1689 or email
info@fjwestcott.com
.
©F.J. Westcott Company
Setup Instructions
Halo & Apollo Portable Studio Kits
Style Series: 1050, 1055
Description
Great for on-location shooting.
1050 and 1055 Product Contains
Description
Great for on-location shooting.
1050 and 1055 Product Contains
[1] 45” Round Halo
[1] 28” Apollo (1055 mono version includes mounting arm)
[1] 42” Silver/White Reflector
[1] 28” Apollo (1055 mono version includes mounting arm)
[1] 42” Silver/White Reflector
INSTRUCTIONS
To mount the Standard Halo
on the light, partially open the Halo and slide the shaft into the umbrella receptacle. Pull the
fabric cover over the light and place the silver cap onto the end of the umbrella shaft. Finish opening up the Halo until the slider clicks into
place and locks open. Close the hook and loop tape around the stand.
place and locks open. Close the hook and loop tape around the stand.
To mount the Halo Mono
onto a mono or power light, fully open the Halo by pushing up the slider on the Halo shaft until it
clicks. Slide the Halo shaft into the umbrella receptacle. Pull the fabric over the reflector and tighten the collar of the light modifier over
the housing of the light. Push firmly on the hook and loop tape to fasten in place.
the housing of the light. Push firmly on the hook and loop tape to fasten in place.
To mount the Apollo onto a standard flash head
, fully open the Apollo by pushing the slider up the umbrella shaft until
it locks into place. Slide the shaft of the Apollo into the umbrella receptacle of the light. Fasten the setscrew down until the Apollo is held
firmly in place. Pull the fabric of the front diffuser panel down and fasten the hook and loop tape to hold
in place. Fasten “X” configuration zippers tightly around the light stand.
firmly in place. Pull the fabric of the front diffuser panel down and fasten the hook and loop tape to hold
in place. Fasten “X” configuration zippers tightly around the light stand.
To mount the Apollo onto a mono light
, loosen the setscrew on the receptacle block at the end of the Mounting Arm.
Remove the receptacle block and set aside. Slide the Mounting Arm (Style #1080) into the umbrella receptacle of the light and tighten
setscrew on the light to hold in place. Fasten the receptacle block back onto the end of the Mounting Arm by tightening the setscrew.
Open the Apollo by pushing the slider up the umbrella shaft until it clicks into place. Insert the umbrella shaft of the Apollo through the
receptacle block opening and tighten the setscrew. Pull the Apollo fabric down around the housing of the mono or power light letting the
controls stay exposed. Slide the “X” configuration zippers into place to tightly enclose the light.
setscrew on the light to hold in place. Fasten the receptacle block back onto the end of the Mounting Arm by tightening the setscrew.
Open the Apollo by pushing the slider up the umbrella shaft until it clicks into place. Insert the umbrella shaft of the Apollo through the
receptacle block opening and tighten the setscrew. Pull the Apollo fabric down around the housing of the mono or power light letting the
controls stay exposed. Slide the “X” configuration zippers into place to tightly enclose the light.