Wasp Bar Code Wasp WPL305 Benutzerhandbuch

1. Place the printer on a flat, secure surface.
2. Make sure the power switch is off.
3. Connect the printer to the computer with the Centronics or USB cable.
4. Plug the power cord into the power supply connector at the rear of the

printer, and then plug the power cord into a properly grounded
receptable.

The printer automatically detects if a ribbon is installed after power on and will
switch to thermal transfer or direct thermal printing mode. If printer does not
detect the ribbon, the motor that drives the ribbon rewind spindle will be
turned off. In case the ribbon is installed but the printer does not detect the

Rear Paper Guides