Wyse X90LE 909522-41L Benutzerhandbuch
10
Chapter 3
Figure 3-2 Connecting the Power Cable
Note
You can connect the power adapter at any time with the thin computer turned
either on or off.
either on or off.
Step 3 - Turn On the Thin Computer
Raise and adjust the lid, and press the power on/off button for two seconds. When you
release the power on/off button, the power LED on the system indicators lights up.
release the power on/off button, the power LED on the system indicators lights up.
After power-on, the thin computer goes through several boot sequence procedures before
the operating system loads. See "Setting Up Access to the Enterprise Servers" for
information about setting up your server environment. Additional information is available in
the thin computers’ operating system documentation, Administrators Guide: Wyse
the operating system loads. See "Setting Up Access to the Enterprise Servers" for
information about setting up your server environment. Additional information is available in
the thin computers’ operating system documentation, Administrators Guide: Wyse
®
9
Series, Based on Microsoft
®
Windows
®
XP Embedded.
Turning Off the Thin Computer
Press the power on/off button for two seconds, or go to Start | Shut Down, choose Shut
Down in the Shut Down Windows dialog box, and click OK.
Down in the Shut Down Windows dialog box, and click OK.
Removing the Battery
With your thin computer turned off, slide the battery lock to unlock, and then slide and hold
the battery release latch to gently pull the battery out of the battery compartment.
the battery release latch to gently pull the battery out of the battery compartment.
Caution
Before removing battery, turn off the thin computer and disconnect the power
adapter from the electrical outlet.
adapter from the electrical outlet.