Wisdom Wands SC-1 Benutzerhandbuch
13
Pl
ea
se
r
ef
er
to
o
w
ne
r's
m
an
ua
l
fo
r
fu
se
r
ep
la
ce
m
en
t
RS232
ON/OFF
~ AC INPUT
USB
12v trigger
SC-1 System Controller
made in USA
www.wisdomaudio.com
IN
PU
T
H
IG
H
O
U
T
LO
W
O
U
T
SUB
OUTS
L
R
C
SL
SR
SBL
SBR
Sub1
Sub2
Sub3
in out
Manufactured under license from Audyssey Laboratories.
U.S. and n patents pending.
MultEQ XT is a trademark of Audyssey Laboratories.
U.S. and n patents pending.
MultEQ XT is a trademark of Audyssey Laboratories.
L
R
C
SL
SR
SBL
SBR
CAUTION--RISK OF ELECTRIC SHOCK--DO NOT OPEN
O 100-120V, 50-60 Hz, @ < 0.5A
O 200-240V, 50-60 Hz, @ < 0.25A
Voltage set at factory for destination country
O 200-240V, 50-60 Hz, @ < 0.25A
Voltage set at factory for destination country
s/n:
FUSE REPLACEMENT
100-120V
T 500mA L 250V
200-240V
T 250mA L 250V
Rear Panel
Caution!
Turn off your power amplifiers before attempting to connect
anything to your Wisdom Audio SC-1.
anything to your Wisdom Audio SC-1.
1
7.3 Channel Inputs
The SC-1 supports multichannel systems of up to 7.3 channel configura-
tions; that is, you may have as many as seven main channels and three
independent subwoofer channels controlled by the SC-1. These ten bal-
anced audio inputs accept signals from a preamplifier/processor with
anced audio inputs accept signals from a preamplifier/processor with
balanced outputs via high quality XLR connectors.
The pin assignments of these XLR-type female input connectors are:
2 1
3
Pin 1: Chassis ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
These pin assignments are consistent with the standards adopted by the
Audio Engineering Society. Refer to the operating manual of your bal-
anced-output preamplifier to verify that the pin assignments of its output
connectors correspond to your Wisdom Audio SC-1. If not, wire the
cables so that the appropriate output pin connects to the equivalent input
connectors correspond to your Wisdom Audio SC-1. If not, wire the
cables so that the appropriate output pin connects to the equivalent input
pin, in order to preserve the polarity of the musical signal.
Connect the output of your preamp/processor to these balanced XLR
inputs. The inputs are in the following order, from left to right as seen from
inputs. The inputs are in the following order, from left to right as seen from
behind the SC-1: Left, Right, Center, Surround Left, Surround Right, Sur-
round Back Left, Surround Back Right, Sub1, Sub2, Sub3.
round Back Left, Surround Back Right, Sub1, Sub2, Sub3.