Whirlwind SAT-1 Merkblatt
1: Volume Controls
Provides separate left/right
volume control. When used in
conjunction with the
Stereo/Mono switch, you can
achieve a “mix” between
channels.
Provides separate left/right
volume control. When used in
conjunction with the
Stereo/Mono switch, you can
achieve a “mix” between
channels.
2: Headphone Outputs
Two outputs are provided for
each of the two sections on the
Satellite module. Each set is
wired in parallel.
Two outputs are provided for
each of the two sections on the
Satellite module. Each set is
wired in parallel.
3: Stereo/Mono Switches
One switch is supplied for each
section of the SAT-1
One switch is supplied for each
section of the SAT-1
4: IN
Input to Satellite Module.
Standard XLR jack is provided
so that hookup can be
accomplished with standard
microphone cables.
Input to Satellite Module.
Standard XLR jack is provided
so that hookup can be
accomplished with standard
microphone cables.
5: THRU
Wired parallel to the input jack,
can be used for “Daisy
Chaining” modules.
Wired parallel to the input jack,
can be used for “Daisy
Chaining” modules.
Optional Equipment: PCHLIP for mounting SAT-1 on a
microphone stand. Available at authorized Whirlwind dealers.
When using headphone impedances of 50 ohms or less, do
not power the SAT-1 with an amplifier rated greater than 45
watts. Failure to observe this will burn out the current limiting
resistors inside the unit and void the warranty.
not power the SAT-1 with an amplifier rated greater than 45
watts. Failure to observe this will burn out the current limiting
resistors inside the unit and void the warranty.
!
L
R
STEREO
MONO
1
2
PHONES
PHONES
SAT-1
SATELLITE
MODULE
IN
THRU
1
2
3
4
5
99 Ling Rd
Rochester, NY 14612
585 663-8820 Fax 585 865-8930
SAT-1
Satellite Module and
Headphone Breakout Box
XLR PINOUT
Pin 1 = shield
Pin 2 = ring (right)
Pin 3 = tip (left)
Pin 1 = shield
Pin 2 = ring (right)
Pin 3 = tip (left)