Watts Radiant WQC4 RO Benutzerhandbuch
Page 4
Hardness: Recommended hardness should not exceed 10 grains per gallon, or 170 ppm. System
will operate with hardness over 10 grains but the membrane life may be shortened. (Addition of a
water softener may lengthen the membrane life.)
will operate with hardness over 10 grains but the membrane life may be shortened. (Addition of a
water softener may lengthen the membrane life.)
1 Tank
1 RO System
1 Parts Bag
1 Faucet Bag
1 RO System
1 Parts Bag
1 Faucet Bag
If any of the items are missing please contact your
dealer.
dealer.
Tools Recommended For Installation
Contents of Reverse Osmosis (RO) System
Note: Reverse Osmosis water should not be run through copper tubing as the purity of the water
will leach copper and cause an objectionable taste in water and may cause damage to copper
tubing. Watts supplies specialty medias that can be used if copper tubing is down stream of
tubing. Watts supplies specialty medias that can be used if copper tubing is down stream of
the RO. Be sure to follow any state or local regulations.
Operational Parameters
Note: The operating pressure in your home should be tested over a 24 hour period to attain the
maximum pressure. If incoming pressure is above 85 psi a pressure regulator is recommended and
if over 100 psi then a pressure regulator is required.
maximum pressure. If incoming pressure is above 85 psi a pressure regulator is recommended and
if over 100 psi then a pressure regulator is required.
1 Manual and Warranty Card
Operating Temperatures:
Maximum 100°F (37.8°C)
Minimum 40°F (4.4°C)
Operating Pressure:
Maximum 85 psi (6.0 kg/cm
2
)
Minimum 40 psi (2.80 kg/cm
2
)
pH Parameters:
Maximum 11
Minimum 2
Iron:
Maximum 0.2 ppm
TDS (Total Dissolved Solids)
< 1800 ppm
Turbidity
< 5 NTU
1 1/4” Hole Saw Bit for Faucet opening and/ or
Round Knock out Punch for Stainless Sinks 1 1/4”
Adjustable Wrench
Sharp Knife
1/2”- 13/16” Open End Wrenches
Phillips Screw Driver
Needle Nose Pliers- Adjustable Pliers
Electric Drill
Round Knock out Punch for Stainless Sinks 1 1/4”
Adjustable Wrench
Sharp Knife
1/2”- 13/16” Open End Wrenches
Phillips Screw Driver
Needle Nose Pliers- Adjustable Pliers
Electric Drill