Woodstock W1410 Benutzerhandbuch

Shop Fox

Fence

-11-

Figure 11. Adjusting the power link.

Figure 12. Setscrew stop.

Step 4.

Bump the handle from underneath. If the handle

can be unlocked by bumping it 3 or 4 times, the

setscrew stop needs to be backed off. If the set-

screw stop is backed out too far, the power link

will pivot past five degrees and the clamping force

will diminish.

Step 5.

Loosen the check nut (#29) with a

⁄

" socket.

Adjust the setscrew stop using a 3mm Allen

wrench until the the power link is 5˚ past hori-

zontal. Test your results. If you can bump the

handle and it releases, incrementally back out the

setscrew stop some more. If the draw bar can be

observed stopping its outward motion and then

begins to reverse direction, turn the setscrew stop

back in.

Step 3.

Slide the vinyl grip (#1) back about half way to

expose the setscrew stop (#28) located on the

underside of the draw bar (#6). Figure 12. The

setscrew stop limits the degree of handle throw.

Setscrew stop

Power link

Check nut

5˚

C. LOCK HANDLE

The lock handle (#2) actuates and holds the clamp-

ing jaws when in the engaged (down) position and

releases the jaws in the up position. This handle is

already adjusted for use out of the box. However,

further adjustment may be necessary after a short

break-in period. To adjust the lock handle:

Step 1.

Push down on handle. Very little effort is required

to do this (15-20 pounds of force).

Step 2.

Check the position of the power link (#5). Figure

11. Notice how the link “cams over” slightly past

horizontal when the handle is engaged. The power

link should be adjusted to “cam over” at approxi-

mately five degrees past horizontal.