Spectralink SpectraLink IP Phone 72-1084-02 Benutzerhandbuch
SpectraLink Corporation
Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks ICP and 5220 IP Phone emulation
PN: 72-1084-02-B.doc
Page 38
Message Description
Action
DO NOT POWER
OFF
OFF
The Wireless Telephone is in a
critical section of the software
update.
critical section of the software
update.
None. Do not remove the battery
or attempt to power off the phone
while this is displayed. Doing so
may require the phone to be
returned to SpectraLink to be
recovered.
or attempt to power off the phone
while this is displayed. Doing so
may require the phone to be
returned to SpectraLink to be
recovered.
Duplicate IP
The Wireless Telephone has
detected another device with its
same IP Address.
detected another device with its
same IP Address.
If using DHCP, check that the
DHCP server is properly
configured to avoid duplicate
addresses.
DHCP server is properly
configured to avoid duplicate
addresses.
If using Static IP, check that the
Wireless Telephone was assigned
a unique address.
Wireless Telephone was assigned
a unique address.
Erase Failed
Download process failed to erase the
memory in the Wireless Telephone.
memory in the Wireless Telephone.
Operation will retry but may
eventually report the error "int.
error: 0F" Power cycle the phone.
eventually report the error "int.
error: 0F" Power cycle the phone.
Erasing Memory
Wireless Telephone has determined
that a download should occur and is
erasing the current software from
memory.
that a download should occur and is
erasing the current software from
memory.
None. When the progress bar fills
the display line the erase operation
is complete.
the display line the erase operation
is complete.
Initializing …
The Wireless Telephone is
performing power on initialization.
performing power on initialization.
None. This is informational only.
Internal Err. # #
The Wireless Telephone has
detected a fault from which it cannot
recover.
detected a fault from which it cannot
recover.
Record the error code so it can be
reported.
Turn the Wireless Telephone off
then on again.
If error persists, try registering a
different Wireless Telephone to
this telephone port.
If error still persists, contact
SpectraLink Technical Support and
report the error.
reported.
Turn the Wireless Telephone off
then on again.
If error persists, try registering a
different Wireless Telephone to
this telephone port.
If error still persists, contact
SpectraLink Technical Support and
report the error.
Network Busy
All APs are full or busy.
Try call again later.
No Host IP
The Wireless Telephone is
configured for “static IP” (as opposed
to “use DHCP”) and no valid host IP
Address (the Wireless Telephone’s
IP Address) has been entered.
configured for “static IP” (as opposed
to “use DHCP”) and no valid host IP
Address (the Wireless Telephone’s
IP Address) has been entered.
Enter a valid IP Address in the
configuration settings or change to
“use DHCP”.
configuration settings or change to
“use DHCP”.
No IP Address
Invalid IP.
Check the IP Address of the
Wireless Telephone and re-
configure if required.
Wireless Telephone and re-
configure if required.
No PBX Response
The Wireless Telephone tried to
send a message to the supported
Mitel Networks VoIP solution and
failed to get a response.
send a message to the supported
Mitel Networks VoIP solution and
failed to get a response.
Verify the supported Mitel
Networks VoIP solution is
operational and connected to the
network.
Networks VoIP solution is
operational and connected to the
network.