Spectralink SpectraLink Cell Phone BPX100 Benutzerhandbuch

SpectraLink Corporation 

NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide 

Part Number: 72-1004-01-H.doc 

Page 50 

SPECIFIC ABSORPTION RATE (SAR) INFORMATION 

Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it 

receives and also sends out radio frequency (RF) signals. In August 1996, the Federal Communications 
Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones. Those 

guidelines are consistent with the safety standards previously set by both U.S. and international standards 
bodies: 

•  ANSI C95.1 (1992) American National Standards Institute 
•  NCRP - Report 86 (1986) National Council on Radiation Protection and Measurements 
•  ICNIRP (1996) International Commission on Non-Ionizing Radiation Protection; 
•  DHWC - Safety Code 6 Department of Health and Welfare Canada 
Those standards were developed by independent scientific organizations through periodic and thorough 

evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety 
of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit 

of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.

Tests for SAR are conducted using standard operating positions specified by the FCC with the phone 

transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at 
the highest certified power level, the actual SAR level of the phone while operating can be well below the 

maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the 
power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower 

the power output. Before a phone model is available for sale to the public, it must be tested and certified to the 
FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. 

The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the 
FCC for each model. While there may be differences between the SAR levels of various phones and at various 

positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment 
Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF 

emission guidelines. SAR information on this model phone is on file with the FCC and can be found under the 
Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID IYGSNP2400 or FCC ID 

IYGRNP2400. Additional information on Specific Absorption Rates (SAR) can be found on the Cellular 
Telecommunications Industry Association (CTIA) web-site at 

4

http://www.wow-com.com.  

The only authorized headsets that may be utilized with the SNP2400 and the RNP2400 are those obtainable 
from SpectraLink or it’s reseller partners. 

The measured SAR of the SNP2400 Wireless Telephone is 
0.61W/kG @ 2462 MHz (head) 0.0379W/kG @ 2412 MHz (body). 

The measured SAR of the RNP2400 Wireless Telephone is 
0.166W/kG @ 2462 MHz (head) 0.0162W/kG @ 2412 MHz (body). 

Hold the handset as you would any other telephone, with the earpiece to your ear and speak into the 
microphone. The internal antenna is then positioned properly. 

 
 

                                                                          

2

 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of 

tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any 
variations in measurements.