Spectra LL100-2 Benutzerhandbuch

6

.COMPONENTS

Open the battery door using your fi ngers, a coin or a screwdriver. 
Insert batteries into the housing so that the negative poles are toward the bigger battery spiral spring. 
Push down on the battery door until the latch “clicks” into position.

Position the laser horizontally or vertically (tripod mount and rubber feet downward!) on a stable platform, wall 
mount or tripod at the desired elevation. The laser recognizes automatically whether it is used horizontally or 
vertically when switched on.

Note: The laser always operates in MANUAL mode in the Vertical position.

Press the power button 1 to turn on the laser. 

Note: The laser always powers up in the automatic self-leveling mode. The LEDs (2, 4 and 5) are 
turned on for 2 seconds. 

The laser is level when the leveling indicator 4 is no longer fl ashing (once every second). 
For the fi rst fi ve minutes after the laser self levels, the LED 4 lights solid. After fi ve minuts the LED 4 starts 
fl ashing every four seconds to let you know the laser is still level while conserving battery life.
If the laser is positioned beyond it´s self-leveling range of ±8%, the laser beam, and manual and leveling 
indicators fl ash simultaneously. Turn the unit off, reposition the laser within the self-leveling range and turn 
it on again.

Note: If the laser is out of its self-leveling range and remains out of it for more than 10 minutes, the 
unit shuts down completely.

Note: After the laser has been level for more than 5 minutes in horizontal mode, 
the HI (height of instrument) alert activates. If the laser is disturbed (tripod bumped, 
etc.) so that when it re-levels the laser beam elevation changes by more than 3 mm 
(1/8 in.), the HI alert shuts down the laser and rotor, and the red LED fl ashes two times per second 
(twice the manual-mode rate). To restore level, turn the laser off and on. After the laser has re-leveled, 
check your initial reference elevation.

In order to switch the laser off, press the power button again.

Standby mode is a power-saving feature that conserves laser battery life.
Press and hold the laser’s or remote control’s manual button for 3 seconds to activate standby mode.

Note: When standby mode is activated, the laser beam, rotor, self-leveling system, and LEDs shut 
down, but the HI alert remains activated.