Znyx Networks bh5700 Benutzerhandbuch

zspconfig - configure and start surviving partner

zspconfig [-d <level>] [-p <directory_path>] [-u 

<dhcp_interface>] [-c <dhclient.conf>] [-t <timeout>] [-s] 
[-v] -f <file>

 zspconfig is used to configure and start the Surviving Partner software.  With the -f option a 
configuration file is provided that completely describes the network setup and desired behavior of 
all of the switches participating in the Surviving Partner.  With the -u option the interface on 
which to run dhclient to retrieve a configuration file must be provided.  The configuration file 
format retrieved by a -u is identical to that supplied with -f.  It is envisioned that the -f option 
is used for initial configuration, and all subordinate and replacement switches run zspconfig 
with the -u option.  The -v option prints the current version of zspconfig and performs no 
actions.  

-d <level> Set the debug level.  The default debug level is 1. 
The higher the level, the more debugging output is produced. 

Debugging output is sent to the console.

-p <directory_path>
Set the directory path for where zspconfig places the scripts 

it generates.  The default location is 
/etc/rcZ.d/surviving_partner.

-u < dhcp_interface>

Come up as an unconfigured slave. Use the specified 
<dhcp_interface> to retrieve the configuration. User 

confirmation is not required unless the –s option is also 
used.

-c <dhclient.conf> 

Use file <dhclient.conf> as the configuration file to dhclient 
when retrieving configuration information. If  –c is not used, 

a default configuration file is created and used. Only valid 
with the –u option.

-t <timeout>

Time to wait in seconds before giving up on 

Ethernet Switch Blade User's Guide

release  3.2.2j

page  328