Viking TMC 148 Benutzerhandbuch

22

Before you can make a selection, the radio
must be tuned into a TMC station. “TMC”
will then appear in the display.
On each station selection key you can store
and recall a maximum of 5 motorways and
A roads. Alternatively, you can store and
recall 5 areas. However, you cannot store
areas and roads at the same time on the
same key.

a) Selecting area(s)
On the back page of these instructions you
will find a map indicating the UK TMC are-
as.
•

Use this map to find out which num-
bers have been allocated to which
areas (e.g. “12” for The Solent; “13” for
Greater London; “11” for The Severn
Estuary, etc.).

•

Press TMC for approx. 2 sec. - the dis-
play will indicate e.g. “MOTORWAY”,
“A ROAD” or “AREA”.

•

Use  /  to select “AREA”.

•

Use << >> to select the input position
(the input field will flash).

The input fields for 3 areas will be displayed
at the same time. Use << >> to select the
other areas.

If you would like to store the information
entered on one of the station selection keys,
•

press the corresponding station selec-
tion key 1 - 5 for approx. 1 sec. (beep).

It is possible to overwrite (alter) the existing
information entered. The new entry must be
stored to delete the old entry.

You can delete the area selected if you
•

press SC briefly.

All of the areas stored on a station selection
key will be deleted if you
•

press SC for approx. 1 sec.

b) Selecting motorways or A roads
The road number can be entered for up to 5
motorways and 5 A roads.
Depending on the route you plan to travel,
select the numbers of the motorways/
A roads from an up-to-date road map. Only
road numbers up to 3 digits are supported,
so for the M7 enter “007”.
•

Press TMC for approx. 2 sec., the dis-
play will read “MOTORWAY”,
A ROAD” or “AREA”.

•

Use  /  to enter the number for the
selected area, select the next input
field, etc.

You can select and store up to a maximum
of 5 areas and activate them as needed.

Notes:
The cursor will not move to the next input
field unless the entry in the last field is a
real area number.
The amount of information provided will
increase with the number of codes entered.
As a result, it is advisable to enter only as
many area numbers as necessary (max. 5).
Following the input of all of the area code
numbers desired, you can activate the in-
put or store it on a station selection key.

If you would like to activate the information
entered without storing it on one of the sta-
tion selection keys,
•

press TMC for approx. 2 sec.