Vermont Castings FK28/2960 Benutzerhandbuch

5

1. Disconnect the leads from the Snapstat terminals. 
2. Use pliers to remove the retainer ring from the 

Snapstat Cover and slip the cover off the wire har-
ness.

3. Reconnect the wire leads to the Snapstat Plate.
4. Using two sheet metal screws from the fan kit, attach 

the Snapstat Plate to the Inner Shroud as indicated 
in Figure 17.

Position the Fan body within the Rear Shroud as shown 
in Figure 18. The Fan’s upper flange should be located 
behind the lip of the opening. Secure the Fan to the 
Shroud using five sheet metal screws and single star 
washer supplied with the kit.

1. Install the Switch within the Switch Bracket that is 

provided with the stove in the Hardware Bag. Use 
the Retainer Nut and Control Knob provided in the 
Fan Kit. (Fig. 19)

2. Attach the Switch Bracket to the left side of the Rear 

Shroud using two sheet metal screws as shown in 
Figure 20.

3. Secure the fan wire harness to the back of the 

Shroud using the Wire Tie plug as shown in Figure 
20.

ST462
seville
install fan

Fig. 18  Install fan body into rear shroud.

ST462

ST463
Seville
install 
Rheostat switch

Switch Bracket

Retainer Nut

Control Knob

Switch Box

ST463

Fig. 19  Install the rheostat switch.

ST462
seville
install fan

Insert Wire Tie 

Here

ST462

Fig. 20  Attach the rheostat switch and wire tie.

St464
Seville
Install snapstat

Snapstat Plate

Leads

Snapstat 

Cover

ST464

Fig. 17  Install snapstat.