Summit ENG. 4358-3412E Benutzerhandbuch

Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush

against the back of the vehicle seat back, if needed.
Thread the vehicle lap belt or lap/shoulder belt
combination through the belt path and out other side.
Buckle.

With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.

To adjust top anchorage

strap: See “Adjusting Top Anchorage  Strap”  section.

If your vehicle does not have an anchor

bracket, tuck the top anchorage strap’s hook under

the child restraint.

After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.

When LATCH is not being
used, fasten belt hooks
together behind the child
restraint as shown.

Forwar

d-Facing Use:

22-40 lbs.

(10.1-18 kg),

34-43” (85.1-110 cm),

Ov
er 1 y

ear of age

.

Place one knee in the
child restraint and push
down firmly while pulling
up on belt to tighten. For
a manual belt, refer to
“Knowing your Vehicle
Belt” section.

4358-3412E Summit  3/2/07  2:55 PM  Page 27