Summit ENG. 4358-3412E Benutzerhandbuch

1.

by the belt:
Press down firmly on the child restraint and remove all the
slack in the belt. Make sure the belt buckle is not up against
the child restraint where the belt cannot be tightened.
Review Locking Clip section and Top Anchorage Strap
Section. If you cannot secure the child restraint tightly,
move it to another seating location.

2.

lever sticks or you cannot get the straps tight
enough around child:
DO NOT LUBRICATE. Check around buckle and harness
release lever for dropped food, sticky spilled drinks, dirt,
leaves, etc. Clean with warm water and/or remove object
with tweezers. If you cannot get the harness to adjust and
remain tight with the buckle securely locked, do not use the
child restraint.

3.

Straighten the harness each time you put your child in the
seat to help prevent twisting. Lock the buckle and tighten
harness and it will be ready for next use.

When using the interal harness, the harness must be
positioned at or above the child’s shoulders.

When using the internal harness, make sure the vehicle lap
belt is locked. When you grasp the the child restraint at the
belt path, it should not move more than about an inch side
to side.

From the back, use a
screwdriver to press in on
lip of upper harness
guides and pop guides
through the front. Pull
cover off headrest.

Hand wash with warm
sudsy water, rinse clean
and air dry. Do not use
bleach or use other harsh
cleaners. Do not dry
clean.

Spot clean harness straps.
Do not machine wash.

Replace seat pad by
reversing order:

Put pad on headrest and
replace harness guides.
Make sure harness
guides tabs go over
metal bar.

Starting from bottom of
child restraint, snap pad
on shell; tuck in pad
around harness adjuster;
pull pad up and over
headrest. Attach the
elastic straps. Make sure
pad is under headrest and
replace lower harness
guides. Rethread harness
(see belt-positioning
booster section).

4358-3412E Summit  3/2/07  2:55 PM  Page 45