Siemens Chem-Ad Series Benutzerhandbuch
Technical Data
Maximum Capacity USGPH (LPH) 60 Hz
LPH @ 50 Hz
LPH @ 50 Hz
0.06 (0.24)
0.16 (0.6)
0.29 (1.08)
0.44 (1.68)
0.2
0.5
0.9
1.4
Max. Back Pressure
120 PSI, 60 Hz / 10 Bar, 50 Hz
Piston Diameter (mm)
3
4.76
6.34
8
Stroke Frequency Max. (SPM) @ 60/50 Hz
144 / 122
Capacity / Stroke Max. (cm
3
)
0.027
0.068
0.12
0.19
Accuracy
± 2 % over 10:1 range (minimum of 20 % stroke length)
Max. Suction Lift at 100%*
6 Ft (2 Meters)
Max. Back Pressure of Return
4.5 PSI / 0.3 Bar
Suction and Return
2m Duo Hose 6mm ID Supplied
Metering Discharge
1/4" OD x 0.040" Wall Thickness
2mm x 4mm
4mm x 6mm
Power Supply
115 V, 60 Hz (230 V, 50 Hz)
(Power Cord and Plug Supplied)
Current (mA) 115/230 VAC
172 @ 60 Hz / 81 @ 50 Hz
Max. Power Input (W) 115/230 VAC
18.7
Enclosure
IP 65
Max. Ambient Temp.
104°F (40°C)
Insulation Class
B
Alarm Output
Low Level and Tank Empty Contact
Low Level and Tank Empty Contact
Dry contact 24 V, 3 Amps AC/DC or 240 V, 3 Amps AC/DC
mA Input
0/4-20 mA (E30) / 0/4-20 mA or 20-4/0 mA (E60 & E60 Plus)
Max. Impedance 50 Ohms
Pulse Input
Dry contact, Min. 15 msec pulse width
E30 Max. Frequency - 144 Pulse/min., E60 & E60 Plus - 50 Hz
Stroke Signal Output
1 Pulse Per Stroke, Dry Contact Rated 24 V DC, 300 mA
Weight
6 lbs / 2.4 Kgs
* Suction lifts with clean, wetted valves
Suction Lance with tank level switches is recommended for all capacities.
All data refers to water at 68ºF as per the instruction manual.
Suction Lance with tank level switches is recommended for all capacities.
All data refers to water at 68ºF as per the instruction manual.
www.usfilter.com
The information provided in this brochure contains merely general descriptions or
characteristics of performance which in case of actual use do not always apply as described or
which may change as a result of further development of the products. An obligation to provide
the respective characteristics shall only exist if expressly agreed in the terms of contract. Chem-
Ad and PM Kits are registered trademarks of Siemens.
characteristics of performance which in case of actual use do not always apply as described or
which may change as a result of further development of the products. An obligation to provide
the respective characteristics shall only exist if expressly agreed in the terms of contract. Chem-
Ad and PM Kits are registered trademarks of Siemens.
Siemens Water Technologies
1901 West Garden Road
Vineland, NJ 08360
www.usfilter.com
wtus.water@siemens.com
1901 West Garden Road
Vineland, NJ 08360
www.usfilter.com
wtus.water@siemens.com
TI 440.600-1 UA 3/06
Tel: 856.507.9000
Fax: 856.507.4125
Subject to change without prior
notice
©Siemens 2006
Materials of Construction
Pump Head: PVDF
Metering Piston/Cylinder: Ceramic
Diaphragm: PTFE-EPDM Composite Diaphragm
Valves: PVDF
Valve Balls: Ceramic
O-Ring: FPM, or EPDM, FFPM/ Isolast
Valve Springs: Hastelloy
Housing/Finish: Thermoplastic Polyester
Metering Piston/Cylinder: Ceramic
Diaphragm: PTFE-EPDM Composite Diaphragm
Valves: PVDF
Valve Balls: Ceramic
O-Ring: FPM, or EPDM, FFPM/ Isolast
Valve Springs: Hastelloy
Housing/Finish: Thermoplastic Polyester
Dimensions (See Literature)
CN 441.600 - Unit Dimensions
CN 441.601 - E11/E30 Control Panel
CN 441.630 - E60-E60 Plus Control Panel
CN 441.650 - OGM Dimensions
CN 441.601 - E11/E30 Control Panel
CN 441.630 - E60-E60 Plus Control Panel
CN 441.650 - OGM Dimensions