Russound Multisource Multiroom Audio Controller/Amplifier CAS44 Benutzerhandbuch

26

The CAS44 controller does not require programming
for the controller or for source setup. All source
setup and control is contained in the CAS-RC
remote control.

The CAS-RC Remote Control is designed for use with
the Russound CAS44 controller amplifier and system
keypads (KP4 and KPL). It is designed to operate
source devices and the audio system keypad, and is
preprogrammed to control Russound components ST2
Tuner and SMS3 Media Server. The CAS-RC controls
up to four devices. 

Note:  S1, S2, S3, S4, Vol +/-, Mute and Power are
system commands and are the same for any source.
All other buttons are dependent upon the device code
associated with the source and may vary from device
to device. 
The following Key Charts provide a general description
of button functions. 

Select a device.  These keys are preset for Russound devices, but can
be re-programmed (see “Programming a Device”). 
S1= Russound Tuner 1
S2= Russound Tuner 2
S3= Russound SMS3 Stream 1
S4= Russound SMS3 Stream 2

Turn the selected zone on or off.

Program sequences.

Select next/previous.
Select the next/previous chapter on some models of 
DVD players.
Press LAST to recall the last-viewed channel.

Raise or lower the sound level.
Press MUTE to turn the sound off or on.

Move the cursor in the menu screens.

Press OK to choose the high-lighted menu option. 
Performs “Enter” function for devices.

Press Enter to choose the high-lighted menu option. 
Performs “OK” function for devices.

Skip backward,  rewind, fast 

forward, skip forward, stop 
pause, or play tracks on disc.

Use Page Up/Down with cable or 
satellite boxes. 
Note: May have to 
learn in these functions. 

View the current channel and 
program information.

Display the menu for the selected device.

Exit the selected device’s menu, guide, or program without
making a menu selection.

Display the program guide for the selected device.

Change inputs on selected device. 
To change inputs on CAS44 use 
S1 - S4 buttons.

Press LAST once to recall the last channel and to page back
one screen in the main menu.

Directly enter channels (e.g., 09 

or 31).  Press OK to send 
channel number  entries on 
some TV models.

Note: S1, S2, S3, S4, Vol +/-, Mute and Power are system com-
mands and are the same for any source. All other buttons are depend-
ent upon the device code associated with the source.
Before proceeding, find the codes for the devices you want to pro-
gram in, under “Manufacturer’s Codes” in this manual. To control
Universal TV, VCR or DVD, Cable or Satellite Receivers, Amplifier or
Tuner, and Auxiliary devices, follow these steps. 
1.

Turn on  the device (e.g., DVD 

player) and if needed, load media.
2.

Press a device key (S1, S2, S3 or S4).

Press and hold SET until the red LED blinks twice, then release.

Enter the first five-digit code for your device.The LED blinks once

as each digit is entered. If the code is valid, the LED blinks twice.
Note: If the LED does not blink twice, repeat steps 2 to 4 and try
entering the code again.
5.

Aim the remote at the device and press a function button. The